Troubleshooting Guide for Secura Soap Dispenser

Are you experiencing issues with your Secura soap dispenser? If the sensor has been activated, but no soap is dispensed, don't worry! There are a few simple steps you can take to troubleshoot and resolve the problem.

Firstly, ensure that the cap is securely replaced and shake the bottle vigorously to eliminate any potential leaks. Then, fill the bottle with distilled water and rinse it thoroughly with warm tap water to remove any soap residue or debris.

To clean the exterior of the pump bottle, use an alcohol swab to gently wipe down the surface. For stubborn build-ups in the exit points, a toothpick can come in handy. If your dispenser is prone to clogging due to frequent use, try flushing the pump with warm water to remove any soap residue.

Another common issue that can cause clogging is the buildup of glycerin in the soap. In this case, you may need to replace the soap or use a different type that has less glycerin content.

If your soap dispenser pump is clogged, there are a few possible reasons why this may occur. Debris getting caught up in the tube can cause blockages, and replacing the filter if it's become clogged can also resolve the issue.

However, if the water doesn't come out easily, it may be a sign that the bottle itself is damaged. To determine whether this is the case, remove the top cap and pour some water into the bottom part of the bottle. If you notice that there isn't enough liquid inside the bottle, then it needs replacing.

In some cases, the issue may not be with the dispenser itself but rather a lack of use or running out of soap. Make sure to check the level of liquid soap in the dispenser regularly and refill it as needed.

By following these simple steps, you should be able to troubleshoot and resolve any issues with your Secura soap dispenser. Remember to always handle the dispenser with care to avoid damaging any parts of the mechanism.